Xantrex Inverter Settings Lead Acid

How To Check And Change Your Xantrex Inverter Settings:

• A brief video on how to make sure your Xantrex inverter is setup correctly!

• Note this should only be done if you are advised to do so by a Hanvey representative or if you are having power issues where you believe a faulty setting is at fault!

• The inverter control panel is located above the driver's door.

• Press the far right button (function) to turn on the backlight.

• Press the function button until you see "System Status" in the top left of the screen.

• Press the enter button to access this menu.

• Scroll down until you have highlighted "FSW3012 00: Basic".

• Press the enter button to access this menu.

• Scroll down to the very bottom and highlight "Basic Settings".

• Press the enter button to access this menu.

• Scroll through the settings on this menu to verify they match the following:

• Batt Type [Flooded]

• Batt Capacity [880Ah]

• Max Chg Rate [55%]*

• Any value between 55 and 60 is acceptable here.

• Charge Cycle [3Stage]

• ReCharge Volts [12.5V]

• AC In Breaker [10.0A]**

• For vans without an Inline Tank Warmer, this should be set to 15.0A.

• This will only apply to vans built prior to 2018.

• Low Batt Cut Out [10.0V]

• If a setting is not correct, scroll to it and press the enter button.

• Use the arrow keys to set it to the correct setting.

• Press the enter button once it is set to store the setting in the panel.

• Once all the settings are verified, press the function button until you are back to the "System Status" screen.

• Thank you so much for being the most important member of the Hanvey family!

• For additional support, please email us at support@gohanvey.com, or call 864-269-2912.